Wells Ag Treker Canopy Land Pride Utility Vehicles - TREKER Canopy Installation Procedure
This procedure is applicable to the following Land Pride Models Series: 4200NT 4200ST 4400NT 4400ST
Note: The canopy is supplied fully assembled. The hardware package contains the hardware necessary for installation.
Note: The canopy frame fits inside the existing roll-cage structure.
1. Remove and discard the existing hardware that secures the top cage members together. You will use new hardware from Wells Ag to connect top cage members together, bolting down the canopy at the same time with the same bolt hole pattern where cross members are connected.
Note: The canopy top has a larger overhang in the front.
2. Secure the canopy to the roll cage using hardware provided. On the Standard models, use the regular 000nuts between the roll cage and the canopy frame; on the Narrow models, use washers as required to 000shim between the roll cage and the canopy frame.
3. Tighten all hardware.
Hardware List Qty. Description 4 20 4 4
Nut, 5/16 Z Washer, Flat, 5/16 Z Nut, Nylock, 5/16 x 18 Z Bolt, 5/16 - 18 x 2 1/2 Z
To use comment box to order place Land Pride Treker name, shipping address and phone # in comment box to place your order and submit. You will receive a invoiced by mail and you can pay by check or pay by credit card. If you would like to talk to a representative call Ph # 1- 256-513-2023 or use comment box below.
$ 299.00 Tread Plate Aluminum // $299.00 Powder Coated Aluminum $ 20.00 shipping if shipped to commercial address. $ 50.00 shipping to residential addresses.
To use comment box to order place Land Pride Treker name and model, shipping address and phone # in comment box to place your order and submit. You will be invoiced after the canopy is shipped. You will receive confirmation that our office has received your info. If you would like to talk to a representative call Ph # 1- 256-513-2023 or use comment box below.